Anchor

Anchor Creator/Individual units 69

135.00 € 135.0 EUR

135.00 €

A single Pozyx anchor with USB power adaptor. Can be used to support TWR positioning in the Creator series or as a tag for the Enterprise series.

Overview

The Pozyx anchor is meant as a reference unit in the DIY series. It can support two-way-ranging (TWR) based positioning. For 3D positioning, at least 4 anchors are required. The anchors are powered through USB or a barrel jack connector. The anchor can be reprogrammed to behave as a tag in the Enterprise system. The anchor does not need an Arduino to work.

  • Works as an anchor for the DIY series
  • Can be programmed to work as a tag in the Enterprise series
  • On-board ultra-wideband transceiver
  • On-board pressure sensor
  • IP20 casing
  • Operating voltage 3.3 V
  • Connection with Arduino on I2C
  • Micro-USB for updating the Pozyx firmware or used as virtual COM port

On board interfaces


  • I2C. communication with the pozyx anchor means of I2C (SCL and SDA pin) and two optional interrupt pins (pins 2 or 3).
  • Micro USB. The micro USB can be used for two purposes: either, for updating the Pozyx firmware in case new features are provided through us. Secondly, it can be used to connect (and power) the anchor to a computer.

Technical specifications

Board

  • STM32F4 microcontroller
  • I2C for serial communication
  • Micro USB for firmware updates
  • 4 general purpose LEDS
  • 2 LEDs for UWB connectivity
  • 4 optional GPIO pins
  • Onboard 3.3V regulator: automatic power selection from battery or usb
  • Size: 6 cm x 5.3 cm
  • Weight: 12 g

Utra-wideband

  • Decawave DW1000 transceiver
  • Onboard chip antenna
  • 10cm accurate ranging
  • Up to 100m range
  • Frequency range 3.5 - 6.5 GHz
  • Up to 6.8 Mbps communication

Motion sensors

  • MPL3115A2 pressure sensor

Resources

  • Pin-out 
  • 3D file