Developer tag (headerless)

Pozyx Creator/Individual units 70

    135.00 € 135.00 € 135.0 EUR

    135.00 €

    Option not available

    This combination does not exist.

    A single developer tag (headerless) and a 1200 mAh battery.

    Overview

    This tag is identical to the shield compatible with Arduino with the exception that the stacking header pins are not present. This makes the tag smaller. The tag provides accurate positioning and motion information. The tag is meant to work in combination with anchors, either from the Creator series or the Enterprise series. The tag does not need an Arduino to work.

    • Works with both the Creator and the Enterprise series
    • On-board ultra-wideband transceiver
    • On-board 9-axis inertial measurement unit
    • On-board pressure sensor
    • Operating voltage 3.3 V
    • Connection with Arduino on I2C
    • Micro-USB for updating the Pozyx firmware or used as virtual COM port

    Description

    The Pozyx developer tag provides accurate positioning and motion information. For this, it utilizes a set of sensors and an ultra-wideband (UWB) transceiver. The principal component is the DW1000 UWB-chip from Decawave that is used for wireless ranging and messaging. Furthermore, the board is equipped with a 9-axis inertial measurement unit for orientation information. 

    On board interfaces


    • I2C. Arduino communicates with the Pozyx tag by means of I2C (SCL and SDA pin) and two optional interrupt pins (pins 2 or 3). Because the I2C bus can be shared with other peripherals, the tag will not interfere with other Arduino shields. The ICSP header from the Arduino is not passed through, hence other boards requiring this interface must be stacked lower than the Pozyx tag.
    • Micro USB. The micro USB can be used for two purposes: Firstly, for updating the Pozyx firmware in case new features are provided by us. Secondly, it can be used to connect (and power) the tag to a computer. This way, the tag can be controlled through the computer without requiring an Arduino.

    Technical specifications

    Board

    • STM32F4 microcontroller
    • I2C for serial communication
    • Micro USB for firmware updates
    • 4 general purpose LEDs
    • 2 LEDs for UWB connectivity
    • 4 optional GPIO pins
    • Onboard 3.3 V regulator: automatic power selection from battery, Arduino or USB
    • Tag-size: 6 cm x 5.3 cm
    • Tag-weight: 12 g

    Ultra-wideband

    • Decawave DW1000 transceiver
    • onboard chip antenna
    • 10 cm accurate ranging
    • Up to 100 m range
    • Frequency range 3.5 - 6.5 GHz
    • Up to 6.8 Mbps communication

     

    Motion sensors

    • BNO-055 chip
    • 3-axis accelerometer
    • 3-axis gyroscope
    • 3-axis compass
    • MPL3115A2 pressure sensor

    Resources


    • Pin-out 
    • 3D file