Creator anchor

Pozyx Creator/Individual units 69

    135.00 € 135.00 € 135.0 EUR

    135.00 €

    Option not available

    This combination does not exist.

    A single Pozyx anchor with USB power adaptor. Can be used to support TWR positioning in the Creator series.

    Overview

    The Pozyx anchor is meant as a reference unit in the Creator series. It can support two-way-ranging (TWR) based positioning. For 3D positioning, at least 4 anchors are required. The anchors are powered through USB or a barrel jack connector. The anchor can be reprogrammed to behave as a tag. The anchor does not need an Arduino to work.

    • Works as an anchor for the Creator series
    • Can be reprogrammed to work as a tag
    • On-board ultra-wideband transceiver
    • On-board pressure sensor
    • IP20 casing
    • Operating voltage 3.3 V
    • Connection with Arduino on I2C
    • Micro USB for updating the Pozyx firmware or used as virtual COM port

    On board interfaces


    • I2C. Communication with the Pozyx anchor means of I2C (SCL and SDA pin) and two optional interrupt pins (pins 2 or 3).
    • Micro USB. The micro USB can be used for two purposes: Firstly, for updating the Pozyx firmware in case new features are provided by us. Secondly, it can be used to connect (and power) the anchor to a computer.

    Technical specifications

    Board

    • STM32F4 microcontroller
    • I2C for serial communication
    • Micro USB for firmware updates
    • 4 general purpose LEDs
    • 2 LEDs for UWB connectivity
    • 4 optional GPIO pins
    • Onboard 3.3 V regulator: automatic power selection from battery or USB
    • Size: 6 cm x 5.3 cm
    • Weight: 12 g

    Utra-wideband

    • Decawave DW1000 transceiver
    • Onboard chip antenna
    • 10 cm accurate ranging
    • Up to 100 m range
    • Frequency range 3.5 - 6.5 GHz
    • Up to 6.8 Mbps communication

    Motion sensors

    • MPL3115A2 pressure sensor

    Resources

    • Pin-out 
    • 3D file